HX Stomp Manual - English

Controller Assign
HX Stomp provides a wide variety of tools for controlling your tone during a performance.
The most obvious controller would be a connected expression pedal (often
assigned to Wah, Pitch Wham or Volume), but you may also assign footswitches to
toggle between two values of a given parameter or parameters, or even have parameters
instantly change when selecting different snapshots within a preset.
If a parameter has a controller assigned, its value appears with white text:
Harmony Delay
1/8
Time
37%
Feedbk
35%
Mix
IMPORTANT! Adding a Wah or Pitch Wham block automatically assigns it to be
controlled by EXP 1. Adding a Volume or Pan block automatically assigns it to
be controlled by EXP 2. With a Mission SP1-L6H Line 6 Expression Pedal, connecting
it to HX Stomp with a Y-cable will just work, and its built-in toe switch
will toggle between any Wah/Pitch Wham and Volume/Pan blocks. Also see
page 42.
Assigning a Controller
1. From Stomp mode, press and hold the knob for the parameter
you wish to control.
HX Stomp jumps to the Controller Assign page and displays your parameter at
Knob 1 (Parameter).
Controller Assign
Harmony Delay
Feedbk
None
NOTE: To manually access the Controller Assign menu, press
Knob 2 (Controller Assign).
2. Press PAGE and then press Knob 3 (Learn).
The button’s brain icon glows blue.
and then
3. Step on a footswitch, move a connected expression pedal,
send a MIDI CC message from your keyboard, etc.
The controller name appears above Knob 2 (Controller).
NOTE: To manually select a controller, turn Knob 2 (Controller).
None
EXP 1 or 2
FS1-FS5
MIDI CC
Snpshot
Removes the controller assignment.
Expression pedals are the most common type of controller, used
to control volume, wah, Pitch Wham, etc.
Stepping on a Stomp mode footswitch can toggle between a parameter's
min and max values.
Selecting FS1-FS5 will display Knob 3 (Switch Type). Turn Knob
3 to select "Moment[ary]" or "Latch[ing]" behavior. Momentary
means the value will change for as long as you hold the switch.
Latching toggles between Min and Max values every time you press
the switch.*
Selecting "MIDI CC" will display Knob 3 (CC#). Turn Knob 3 to
select the desired MIDI CC number.
Although all controller-assigned parameters are updated per snapshot,
an additional "Snapshots" controller is available when other
controllers are already used.
*NOTE: Footswitch behavior (momentary or latching) is determined per
footswitch, not per assignment.
NOTE: HX Stomp has reserved specific MIDI CC messages for global functions;
these CCs cannot be used as controllers. If you attempt to learn a CC
message reserved for global functions, the following dialog appears:
This CC# is reserved!
Param
Controller
Learn
See "MIDI CC" for more information.
37