HX Stomp Manual - English

4. If desired, press PAGE and turn Knob 1 (Min Value) and Knob
2 (Max Value) to set the range you wish to control.
TIP: To reverse controller behavior, swap the min and max values.
5. Press to return to the Home screen.
SHORTCUT: To assign a parameter to the Snapshots controller, it's even
easier—just push and turn the parameter's knob. The value appears in
white text, indicating it's now assigned to a controller.
SHORTCUT: Hold ACTION and press a parameter knob to quickly
remove any controller assignment (including the Snapshots controller).
The value's text changes from white back to its original color, indicating no
controller is assigned to it.
Clearing a Block's Controller Assignment(s)
1. From the Controller Assign screen, select the block whose
controller assignments you want to clear and press ACTION.
2. Press Knob 1 (Clear Controller).
Tips for Creative Controller Assignment
• By default, a parameter's Min and Max values will be pretty extreme. It pays to
play pretty conservative here, as subtle parameter adjustments go a long way.
• To smoothly blend between the tone on parallel paths A and B, select a Split
> A/B block and assign the Route To parameter to an expression pedal. By
default, a heel-down position means the signal passes fully through Path A.
Moving the pedal toward the toe-down position will gradually crossfade into
Path B. Alternatively, assign a footswitch to control the Route To parameter, for
instantly switching back and forth.
• If you're looking for an ultra-clean boost, instead of adding a Volume/Pan >
Gain block, try assigning a footswitch to increase the Level parameter of a
Mixer or Output block.
• If you have a favorite delay or reverb pedal, use an FX Loop block to insert it
into your tone. Assign EXP 1 or 2 to control the block's Mix parameter, which
will smoothly blend the pedal into your tone.
• For extreme psychedelic dub delay squeals, assign a footswitch to both increase
a Delay's feedback and decrease its time.
• Assign a footswitch to toggle between two Delay > Time parameter values,
such as 1/4 and 1/8 dotted.
• Assign IR Select to a footswitch. Set the two IRs as min and max values. Now
you can instantly toggle between them.
Clearing All Controller Assignments
1. From the Controller Assign screen, press ACTION.
2. Press Knob 2 (Clear All Controller) to clear all blocks' controller
assignments.
The following dialog appears:
Clear all controllers?
Cancel
OK
3. Press Knob 3 (OK).
IMPORTANT! Clearing All Controller Assignments also removes the Wah and
Volume assignments from EXP 1 and EXP 2. Use this function with caution!
38