OVERDRIVE® - RustoleumIBG.Com
OVERDRIVE® - RustoleumIBG.Com
OVERDRIVE® - RustoleumIBG.Com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PRODUCT APPLICATION<br />
TECHNICAL DATA<br />
OVERDRIVE ®<br />
MIXING<br />
The minimum temperature for application should be 65°F.<br />
For low temperature applications, consult Rust-Oleum. Use<br />
only motorized mixers. Hand mixing will produce inconsistent<br />
results. For each 1 gal. of OverDrive ® (part A and part B mixed),<br />
add 60 lbs. of aggregate (30 lbs. of 1/8-1/4 inch pea gravel<br />
plus 30 lbs. of clean graded 30-40 mesh sand). This mix will<br />
fill approximately 1/2 cubic foot area. The aggregate may be<br />
purchased locally or from Rust-Oleum.<br />
Pour part A (resin) and part B (hardener) into mixer. Mix for<br />
about 30 seconds. Immediately add pea gravel and sand. Mix<br />
only long enough to thoroughly disperse the aggregate (1.5 to<br />
3.0 minutes). Immediately pour onto the concrete.<br />
Because sand and gravel size will vary from region to region,<br />
the recommended 30 lbs. of 1/8-1/4 inch pea gravel and 30<br />
lbs. of sand is only a good starting point. If the mix is too wet,<br />
more sand and gravel can be added or 480 silica sand can be<br />
used. If the mix appears too dry, decrease the amount of sand<br />
or gravel accordingly.<br />
Note: Mixing ratios are supplied in kits and on container labels.<br />
For additional adhesion of toppings to OverDrive ® , a silica<br />
broadcast of 50 lbs. per 10 sq. ft. will provide an additional<br />
tooth for binding a heavy duty system.<br />
CLEAN UP<br />
Xylene can be used to remove material from equipment if it is<br />
cleaned before the material has started to set up; otherwise,<br />
stronger solvents such as methylene chloride will be necessary.<br />
If there are any questions on the use of this product, please<br />
consult our technical service department.<br />
SAFETY<br />
OVERDRIVE contains amine curing agents. Avoid skin contact.<br />
In case of eye contact or ingestion, contact a physician<br />
immediately. In case of skin sensitivity to these materials, use<br />
protective clothing and gloves.<br />
MATERIAL SAFETY DATA SHEETS<br />
Material Safety Data Sheets are available upon request. It<br />
is strongly recommended that they be read by all persons<br />
handling OverDrive ® .<br />
2<br />
Form: TB9819990<br />
Rev.: 022409