OVERDRIVE® - RustoleumIBG.Com

More documents

Recommendations

Info

PRODUCT APPLICATION TECHNICAL DATA OVERDRIVE ® MIXING The minimum temperature for application should be 65°F. For low temperature applications, consult Rust-Oleum. Use only motorized mixers. Hand mixing will produce inconsistent results. For each 1 gal. of OverDrive ® (part A and part B mixed), add 60 lbs. of aggregate (30 lbs. of 1/8-1/4 inch pea gravel plus 30 lbs. of clean graded 30-40 mesh sand). This mix will fill approximately 1/2 cubic foot area. The aggregate may be purchased locally or from Rust-Oleum. Pour part A (resin) and part B (hardener) into mixer. Mix for about 30 seconds. Immediately add pea gravel and sand. Mix only long enough to thoroughly disperse the aggregate (1.5 to 3.0 minutes). Immediately pour onto the concrete. Because sand and gravel size will vary from region to region, the recommended 30 lbs. of 1/8-1/4 inch pea gravel and 30 lbs. of sand is only a good starting point. If the mix is too wet, more sand and gravel can be added or 480 silica sand can be used. If the mix appears too dry, decrease the amount of sand or gravel accordingly. Note: Mixing ratios are supplied in kits and on container labels. For additional adhesion of toppings to OverDrive ® , a silica broadcast of 50 lbs. per 10 sq. ft. will provide an additional tooth for binding a heavy duty system. CLEAN UP Xylene can be used to remove material from equipment if it is cleaned before the material has started to set up; otherwise, stronger solvents such as methylene chloride will be necessary. If there are any questions on the use of this product, please consult our technical service department. SAFETY OVERDRIVE contains amine curing agents. Avoid skin contact. In case of eye contact or ingestion, contact a physician immediately. In case of skin sensitivity to these materials, use protective clothing and gloves. MATERIAL SAFETY DATA SHEETS Material Safety Data Sheets are available upon request. It is strongly recommended that they be read by all persons handling OverDrive ® . 2 Form: TB9819990 Rev.: 022409
TECHNICAL DATA OVERDRIVE ® PERFORMANCE CHARACTERISTICS COMPRESSIVE STRENGTH METHOD: ASTM C579 TYPICAL VALUE: 14,000 psi FLEXURAL STRENGTH METHOD: ASTM C580 TYPICAL VALUE: 4,700 psi TENSILE STRENGTH METHOD: ASTM C307 TYPICAL VALUE: 2,400 psi BOND STRENGTH TO CONCRETE METHOD: ASTM D4541 TYPICAL VALUE: Exceeds tensile strength of concrete (concrete fails first) TABER ABRASION METHOD: ASTM 4060, CS 17 TYPICAL VALUE: Loss/1000 cycles = 30 mg. WATER ABSORPTION METHOD: ASTM C413 TYPICAL VALUE: 0.1% maximum LINEAR SHRINKAGE METHOD: ASTM C531 TYPICAL VALUE: 0.12% maximum FLAMMABILITY METHOD: ASTM D635 TYPICAL VALUE: Self-extinguishing IMPACT RESISTANCE METHOD: Mil-D-3134J TYPICAL VALUE: Satisfactory per 3.16 COEFFICIENT OF FRICTION METHOD: ASTM D2047 TYPICAL VALUE: 0.6 minimum FILM HARDNESS, SHORE D METHOD: ASTM D2240 TYPICAL VALUE: 85 3 PERFORMANCE CHARACTERISTICS (cont.) POROSITY WITH NO SEALER METHOD: NACE Stand TM-01-74 TYPICAL VALUE: 0.00 USDA APPROVAL Yes Form: TB9819990 Rev.: 022409
Page 1: EPOXY GROUT DESCRIPTION TECHNICAL D

OVERDRIVE® - RustoleumIBG.Com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?