Manual UV24-Operating-Instructions-8.26.19

More documents

Recommendations

Info

Step 7:With the mount in position drive the #6 self-drilling fasteners through the holes in themount flange, through the ceiling material, and through the ceiling grid structural members.Pay close attention to insure the screws fully penetrate the ceiling grid structural membersand tighten properly against the mount flange. (Cutaway view provided for illustration, theceiling will normally be solid as shown in the previous pictures)(Hard Ceiling Mount, Flange) (Sheet Rock) (Structural Ceiling Beam) (Image 24)When using self-drilling screws, make sure the threaded portion of the screw is long enough totraverse all ceiling material and completely pass through the structural ceiling member.Take care not to strip out the fastener in the structural ceiling members. (Structural ceilinggrids are usually made from lightweight aluminum and can be stripped if close attention is notpaid during installation. If you do strip even a single screw hole, the fixture must be movedslightly to a new positon that allows all fasteners to be re-installed so there are no strippedscrew holes. Please consult the ceiling grid manufacturer’s guidelines regarding the safeminimum and maximum whole spacing.IMPORTANT NOTICE: When installing the VidaShield UV24 Hard Ceiling Mount, all screws mustbe utilized and all screws must pass through the structural ceiling grid. These two requirementsmust be completely achieved or the installation will not meet OSHPD compliance requirementsand could result in damage or injury.(24)Rev. 8/26/19 18
Step 8:After all fasteners have been installed on both long (4ft.) sides of the mount, remove thetemporary mounting brackets. Install the remaining fasteners on each end of the mount.(Image 25)Step 9:When all screws are installed, perform a final inspection to insure all fasteners are securedagainst the face of the mount flange. Installation of the hard ceiling mount is now completeand the VidaShield UV24 unit can be installed into the mount as outlined in the overview.Step 10:OSPHD Compliant Hard Ceiling Mount Installation can be completed.(25)Rev. 8/26/19 19
Page 1 and 2: Continuous Antimicrobial Air Cleane
Page 3 and 4: Thank you for purchasing VidaShield
Page 5 and 6: Note: This device should not be use
Page 7 and 8: utilizes a LED panel and a polycarb
Page 9 and 10: Using the 3/16” drill bit, enlarg
Page 11 and 12: Shoulder BoltSlider Joint(9) (10)At
Page 13 and 14: Male portion of thepower connector(
Page 15 and 16: Step 1:OSPHD Compliant Hard Ceiling
Page 17: Both temporary mounting brackets in
Page 21 and 22: is installed, whole room bacterial
Page 23 and 24: protection suited for UVC light, re

Manual UV24-Operating-Instructions-8.26.19

Create successful ePaper yourself

Delete template?

Save as template?