Manual UV24-Operating-Instructions-8.26.19

More documents

Recommendations

Info

Step 1:Remove the VS01, VS02, and/or VS03 from the packaging to locate a completely assembleddevice. (Image 1, 2)(1)(2)Step 2:Each model of the VidaShield UV24 product (01, 02, & 03) will require two mounting bracketsthat will be located within the packaging. The VS01 product will also be packaged with twofluorescent lamps and an acrylic lens that will be supplied within the installation kit. The VS02Rev. 8/26/19 6
utilizes a LED panel and a polycarbonate lens and the VS03 product does not provide a roomlight and instead utilizes a standard pattern acoustical ceiling tile. (Image 3)(3)Step 3:Prep the ceiling and remove any existing fixture. A contractor will be needed to run power tothe appropriate locations.• The VS01 (fluorescent) & VS02 (LED) will require two circuits.1. Switch circuit that will operate the downlight2. Constant hot circuit operating the UVC lamp• The VS03 (no ceiling light) will require one circuit.1. Constant hot circuit operating the UVC lampStep 4:Install 4 separate 12 gauge supplementary hanger wires to the existing supports by followingdiagram below from each corner of the unit. (60cm by 120cm for the European models) (Image 4)Rev. 8/26/19 7
Page 1 and 2: Continuous Antimicrobial Air Cleane
Page 3 and 4: Thank you for purchasing VidaShield
Page 5: Note: This device should not be use
Page 9 and 10: Using the 3/16” drill bit, enlarg
Page 11 and 12: Shoulder BoltSlider Joint(9) (10)At
Page 13 and 14: Male portion of thepower connector(
Page 15 and 16: Step 1:OSPHD Compliant Hard Ceiling
Page 17 and 18: Both temporary mounting brackets in
Page 19 and 20: Step 8:After all fasteners have bee
Page 21 and 22: is installed, whole room bacterial
Page 23 and 24: protection suited for UVC light, re

Manual UV24-Operating-Instructions-8.26.19

Create successful ePaper yourself

Delete template?

Save as template?