SINUMERIK 840D sl CNC Software with ShopMill ... - Siemens support

SINUMERIK 840D sl 2011-08-031
CNC Software with ShopMill 1.5 SP4
Exactly one NCU with SyncModeDHCPD_SysNet = ON_MASTER
On PCU 50, you have to use PCU base software V8.1 SP3 or later.
In the System Network Center, tab TCU Support, leave the default configuration "Complete TCUsupport"
unchanged. Under the tab DHCP Settings, we recommend to set "Sync mode low priority".
All operator stations within the plant / system network (TCUs, HT8, PCU 50) are managed on the NCU
with "ON_MASTER", that means the config.ini files as well as the .leases file comprising all IP
addresses assigned within the system which are relevant during the runtime are stored there.
The config.ini files are distributed to all other NCUs / PCUs by the master NCU using the service
command "sc distribute tcudata".
Via the Service command "sc clear dhcp" and subsequent power ON / OFF of the complete system, the
NCUs / PCUs are assigned preset IP addresses. New addresses are assigned to TCUs and MCPs and
the .leases file is then distributed to all other NCUs / PCUs.
Important: The System Network Center, tab OPs allows to directly edit on each PCU 50 the config.ini
files of all operator stations on the master NCU. The data are automatically distributed to all NCUs /
PCUs each time they are changed.
9. Information about technology cycles:
NCU CNC software 1.5 SP31 includes the technology cycles (standard cycles) 07.05.096 in an installable form.
Functionality:
This cycle release includes new functions, improved functionality and debugs. Only the differences with
respect to SW 07.05.04.00 are described in this document.
New functions / expanded functionality / function improvements from SW 07.05.08.00 onwards:
2. Changing the cutting cycle (CYCLE95)
When only finishing, the contour is now always machined in the programmed direction - just the same as
it is documented. For complete machining the contour is finished exactly the same as it is also roughed;
this means that one and the same tool can be used for roughing and finishing.
Documentation
The current documentation for this SW release is as follows:
“Cycles Programming Manual” Edition 01.2008
Order No. [MLFB] 6FC5398-3BP20-1AA0
Compatibility Prerequisites:
Software HMI:
HMI-Advanced
from SW 7.5
Software NCU:
Software 840D sl NCU 7x0.x 1
from SW 1.5
with HMI-Embedded
from SW 7.5
with ShopMill-HMI
from SW 7.5
with ShopTurn-HMI
from SW 7.5
For applications involving angled tools with swivel cycle (CYCLE800):
1
For applications with SW from 2.5, please note Attachment_3!
© Siemens AG 2011
All rights reserved
I DT MC R&D 51 Page 12 of 39