Operating instructions Urban Milk Shuttle Calf milk ... - Demsa Genetik

Programming and calibrating
7.3.1.2 Calibrating
When calibrating the function "Time dosing", feed is conveyed for 10 seconds. The
conveyed amount is measured by the user and entered in the control.
INFO
INFO
To do so, carry out the following steps:
1. Use + /
2. Press
appears:
SET
–
to select the "Time dosing" function:
(>3 sec) long until the following display (example)
3. Actuate the pump nozzle over a collecting tray until the feed pump stops
automatically. Hold the pump nozzle at the same height as when dosing later on to
achieve the greatest possible precision.
4. Measure the conveyed feed amount.
Info
You can measure the feed amount alternatively in kg or in litres. The chosen unit (kg or
litre) must then be used when entering the required volumetric delivery.
5. Briefly press SET
6. Use + /
7. Press
SET
–
to enter the measured feed amount (e.g. 6.2 l):
briefly to exit the calibrating menu.
Info
The precision of the time-controlled dosing depends on several factors, e.g.:
• Charge condition of the battery
• Fill level of feed container
• Height of pump nozzle
• Ambient temperature
An even greater precision is achieved with the (optionally available) "Sensor dosing"
function.
34
Time dosing
004.0 1. 02.0
Time calibration
10 sek 05,000
Time calibration
> 06,200