Sound Cube - TDK

More documents

Recommendations

Info

REAR 1. DC IN Jack 18V z (AC ADAPTER PART NO. 151-UGPE30200-E*) 2. USB Jack (USB CABLE PART NO. 174-9USBBGBW-E*) 3. RCA IN Jacks 4. LINE IN Jack LOCATION OF CONTROLS (CONTINUED) 1 2 3 4 5 6 *Consumer Replaceable Part (See page 19 to order.) 5 5. INST (Instrument) Jack 6. Battery Compartment (Bottom of Unit) (BATTERY COVER PART NO. 309-ABS-05134-0BAE* BATTERY SCREW PART NO. 353-0607176-E*)
AC CONNECTION Insert the small end of the AC adapter into the jack on the rear of the unit. Insert the other end (with the 2 blades) into a conveniently located AC outlet having 120V AC, 60Hz. AC ADAPTER SPECIFICATIONS: DC 18V Z NOTES: • To disconnect the AC adapter, remove it from the DC IN jack on the side of the unit as well as from the AC outlet. • Use the enclosed AC adapter for this product only. INSERTING BATTERIES To use this unit with battery power, remove the Battery Compartment cover on the bottom of the unit by removing the two screws with a flathead screwdriver, and then lifting the cover off. Insert twelve (12) “D” cell batteries (not included), observing the battery polarity indicated inside the compartment. Replace the Battery Compartment cover and screws. NOTE: The AC adapter must be disconnected from the jack on the rear of the unit in order for the unit to operate on battery power. We recommend Alkaline or rechargeable types for maximum cycle time and ecological efficiency. POWER SOURCES 6 + – + – + – + – + – + – + – + – + – + – + – + – Tomada de CA Plugue do adaptador C Para o plugue de entrada CC BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Caution – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 2. Use only the size and type of batteries specified. 3. Be sure to follow the correct polarity when installing the batteries as indicated in the Battery Compartment. A reversed battery may cause damage to the device. 4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old batteries with fresh ones. 5. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s directions.) 7. Remove batteries promptly if consumed. 8. Clean the battery contacts and also those of the device prior to battery installation.
Page 1 and 2: Sound Cube HIGH-FIDELITY STEREO BOO
Page 3 and 4: IMPORTANT SAFETY INSTRUCTIONS WARNI
Page 5: FRONT LOCATION OF CONTROLS 1 2 3 4
Page 9 and 10: USING THE FM RADIO 1 SOURCE EQ Turn
Page 11 and 12: USING AN iPod 1 SOURCE EQ Turn this
Page 13 and 14: 5 SOURCE EQ O ®p n Repeat step 4 u
Page 15 and 16: REPEAT PLAYBACK 1 SOURCE EQ O ®p n
Page 17 and 18: 1 SOURCE EQ Turn this unit on by ro
Page 19 and 20: TROUBLESHOOTING GUIDE No Sound - Ge
Page 21: USER GUIDE Imation Enterprises Corp

Sound Cube - TDK

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?