Engine Air Cleaners, Intake Accessories and ... - Giro Servicios CA

Intake Accessories
Exhaust Ejectors
A Donaldson exhaust ejector mounts as a stack at the end
of exhaust system (stack caps or extension tubes may be
added). The ejector is used with a Donaldson Donaspin
pre-cleaner or Strata system – typically used in offhighway
equipment to extend air filter life.
To fit your space and design requirements, three exhaust
ejector styles are available. All are constructed of heavygauge,
aluminized steel. Select the appropriate ejector by
the intake airflow (CFM) of your engine.
Expanded I.D.
End Style
Expanded End Style
Compact Style
Standard Style
How It Works
Engine Scavenge Ejector Exhaust
Part Intake -- Inlet I.D. -- Tube O.D. --- Length --- Flow Rate (CFM)
Number CFM inch mm inch mm inch mm Min.1 Max.2
H002129 3 500-715 5.17 131 1.50 38 29.50 749 1270 1800
H002131 4 780-1110 6.19 157 2.00 51 32.50 826 1985 2800
H002132 4 1040-1475 6.19 157 2.00 51 32.50 826 2625 3715
Donaspin Pre-Cleaner
Cleaned Air
Intake Air
Silicone Hose
Scavenge Line
The Donaspin pre-cleaner uses a spinning
motion of the airstream to force dirt and debris
to the outside wall of the pre-cleaner body. The
dirt and debris are forced to the bottom of the
pre-cleaner and expelled by the secondary
airflow developed by the ejector.
EXPANDED STYLE
INSTALLATION
Ejector
MaxGrip Clamp
Muffler
Outlet
End
Exhaust Air
82 Engine Air Cleaners, Accessories & Service Parts www.donaldson-filters.com
Ejector
Expanded I.D. End
Simplifies installation - requires less parts to install
No need for separate connector!
Fits over most standard muffler outlet tubes
Adds only 4" (102 mm) to 8" (203 mm) H20 (.3" to .6" Hg.)
to exhaust backpressure
Standard
Can be used with any pre-cleaner style
Adds only 4" (102 mm) to 8" (203 mm) H20 (.3" to .6" Hg.)
to exhaust backpressure
Compact
Used primarily on agricultural equipment
Adds 10" (254 mm) to 15" (381 mm) H20 (.75" to 1.1" Hg.)
to exhaust backpressure