SLIDING DOOR SYSTEM_ AIR PRODUCT LIST - Raumplus

More documents

Recommendations

Info

SYSTEM DESCRIPTION_ AIR SLIDING DOOR SYSTEM 36 7.4_ S3000 Alignment options / wall-mounted, typical and oversized overlap Typical overlap Oversized overlap NOTE: Door can not travel past fl oor guide. To clear opening you must oversize the door. raumplusna.com V2013.1
7.5_ S3000 Alignment / offset bypass 7.6_ S3000 Alignment notes Each AIR door is held in vertical plane at three points: the two top rollers and the ground plate with roller (fl oor guide). System description_ AIR_ S1500, S3000, Solid Door hardware Sliding door system For wall-mounted doors, with a typical overlap (one stile each side of opening) the door will project into the opening by 37mm [2 7/16"] when in the open position. To fully clear the opening, a door must be oversized with an overlap on one side at a minimum of 96mm [3 3/4"]. For a symmetrical overlap the amount of the overlap must be doubled. These rules apply to single ceiling- or wall-mounted doors. If installing as a pocket door with pre-shipped tracks please specify that the rollers ship with the tracks. The rollers must be in the tracks before the tracks are installed. raumplusna.com V2013.1 37
Page 1 and 2: SLIDING DOOR SYSTEM_ AIR PRODUCT LI
Page 3 and 4: SYSTEM DESCRIPTION_ AIR SLIDING DOO
Page 5 and 6: 2.2_ S1500 Isometric view / ceiling
Page 7 and 8: 2.4_ S3000 Isometric view / ceiling
Page 9 and 10: 2.6_ AIR Solid door hardware isomet
Page 11 and 12: 4_ Panels System description_ AIR_
Page 13 and 14: System description_ AIR_ S1500, S30
Page 15 and 16: 5_ Top tracks 5.1_ AIR Top track 5.
Page 17 and 18: 6_ Accessories 6.1_ AIR End cap for
Page 19 and 20: 6.5_ AIR Stopper with positioner 6.
Page 21 and 22: 6.11_ AIR S1500 Ganging device, lef
Page 23 and 24: 6.15_ AIR Synchro 6.16_ 45° Corner
Page 25 and 26: 6.20_ Square with circle cut-out ap
Page 27 and 28: 6.26_ Post 6.27_ Frame lock for S30
Page 29 and 30: 6.29_ Panel Lock, key-lock for S150
Page 31 and 32: 6.31_ Panel Lock, key-lock for S300
Page 33 and 34: 6.35_ Brush gasket 6.36_ Rubber gas
Page 35: 7.2_ S1500 Alignment / offset bypas
Page 39 and 40: 8.2_ S1500 Ganging / double, right
Page 41 and 42: 8.5_ S3000 Ganging / double, right

SLIDING DOOR SYSTEM_ AIR PRODUCT LIST - Raumplus

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?