COMPOUND BOW OWNER'S MANUAL - Bear Archery

ADJUSTING DRAW LENGTH
Rotating Module Cam
Note the string side of the cam has 2 axle holes numbered
1 and 2 (Fig. 1). You must relax the limbs of the
bow to change the axle locations. This can be achieved
either by relaxing the limb bolts or using a bow compressor.
The opposite side (fig. 2), the rotating module has
the letters A, B, C and D. There are also indicator marks
numbered 1 and 2. The indicator marks correspond to
the axle position on the opposite side of the cam. Use
the below information to set the draw and module position
for the desired draw length.
(Fig. 1 and 2 are on the following page)
Draw Length Axle Hole Module
20 2 2-D
21 2 2-C
22 2 2-B
23 2 2-A
24 1 1-D
25 1 1-C
26 1 1-B
27 1 1-A
24