Design-in Guide for Xtreme drivers low wattage - Philips Lighting
Design-in Guide for Xtreme drivers low wattage - Philips Lighting
Design-in Guide for Xtreme drivers low wattage - Philips Lighting
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Appendix 2<br />
How to switch from standard DynaVision gear to DynaVision <strong>Xtreme</strong> gear<br />
2.1 Introduction<br />
This document describes the problems you will face when replac<strong>in</strong>g exist<strong>in</strong>g HID PV and DV electronic lamp <strong>drivers</strong><br />
by an HID PrimaVision or DynaVision DALI <strong>Xtreme</strong> lamp driver.<br />
2.2 Version management<br />
8-2-2011: Version 0.1<br />
Initial document<br />
2.3 Present situation<br />
<strong>Philips</strong> is currently phased over from HID PrimaVision and DynaVision electronic lamp <strong>drivers</strong> (also known as<br />
„GEN3‟) to HID PrimaVision and DynaVision DALI <strong>Xtreme</strong> lamp <strong>drivers</strong>. Electrically, this will be a m<strong>in</strong>or issue, but<br />
<strong>for</strong> systems that previously used a stepless 1-10V dim signal there is no alternative available. If the 1-10V dim signal<br />
was generated by an SDU 01/11, please see application note: „How to use DynaVision <strong>Xtreme</strong> ballast with L<strong>in</strong>e<br />
Switch‟.<br />
2.4 Mechanical outl<strong>in</strong>e<br />
The height and footpr<strong>in</strong>t of the <strong>Xtreme</strong> lamp driver are different to the PrimaVision / DynaVision non-<strong>Xtreme</strong> lamp<br />
driver.<br />
See pictures be<strong>low</strong> <strong>for</strong> the differences<br />
<strong>Philips</strong> HID-PV / DV <strong>Philips</strong> HID-PV / DV <strong>Xtreme</strong><br />
A 90mm 65mm Width<br />
B 70mm 47mm Spac<strong>in</strong>g between mount<strong>in</strong>g holes<br />
C 4.5mm 5mm Diameter of mount<strong>in</strong>g hole<br />
D 40mm 65mm Height<br />
E 150mm 150mm Length<br />
F 134mm 135mm Distance between mount<strong>in</strong>g holes<br />
The ma<strong>in</strong> differences are the height and width of the new <strong>Xtreme</strong> lamp driver.<br />
30