Hicom 150 Programming Guide - Strategic Business Systems, Inc.

15_8.c08
For internal distribution only Configuration Guidelines
CorNet-N Networking (Not for U.S.)
Line 3: Dialed digit 6-XX refers to route table 2 (plan for CorNet-N stations 600 to 699)
Line 4: Dialed digit 77CZ refers to route table 1 (plan for trunk calls from primary system
Make the following entries in route table 1 of the Route table window:
(table for trunk calls)
Line 1: Route 1, Dial rule 1, No warning
Make the following entries in route table 2 of the Route table window:
(table for CorNet-N calls)
Line 1: Route 2, Dial rule 2, No warning
Make the following entries in the Dialing rules table window:
Line 1: Rule name CO, Rule format A, Procedure Primary carrier (rule for trunk calls)
Line 2: Rule name CorNet-N, Rule format E1A, Procedure Corporate Network (rule
for CorNet-N calls)
Programming the Satellite System Using Hicom Assistant E
From the Lines/networking menu, go to the Routes window and select route 1.
Make the following settings:
Enter the route name and set the second trunk code digit to 0 (0 is the first trunk group
code of route 1in the satellite system).
Delete the trunk group code for route 1.
In the Routing parameters window, set the route type to PABX. Set Number and
type, outgoing to PABX number.
In the Trunks window, double-click the ellipsis (...) for the trunk in the Param column
to set the protocol to S 0 : Cornet-N variant 2 satellite (direct).
In the System parameters, Diversion/Attendant window, note that the station number
of the external attendant code should be deleted. Also deactivate Automatic line
seizure under Flags/CMI.
Go to the Least cost routing window and release LCR.
Make the following entries in the Dial plan window:
Line 1: Dialed digit 0CZ refers to route table 1 (plan for trunk calls)
Line 2: Dialed digit 1-XX refers to route table 2 (plan for CorNet-N stations 100 to 199)
Line 3: Dialed digit 2-XX refers to route table 2 (plan for CorNet-N stations 200 to 299)
Line 4: Dialed digit 3-XX refers to route table 2 (Plan for CorNet-N stations 300 to 399)
G281-0666-01, August 2000
Hicom 150 E Office, Rel. 2.0-3.0, Service Manual 8-53