Hicom 150 Programming Guide - Strategic Business Systems, Inc.

15_8.c08
For internal distribution only Configuration Guidelines
Tenant Services (Not for U.S.)
8.50 Tenant Services (Not for U.S.)
Parameters for the Example
Restrictions
Example
Two customers (customer A and customer B) seize the trunk by dialing 0.
● Both customers (A and B) telephone each other without having to dial a number
via the trunk.
● Customer A seizes the trunk of customer B (including system speed dialing and
allowed/denied lists).
● Customer B cannot seize the trunk of customer A (including system speed dialing
and allowed/denied lists).
● The trunk of customer A can be transferred to customer B.
● The trunk of customer B can be transferred to customer A.
● Transfer of undialed trunks is not possible.
● Simplified dialing is not possible.
● Speed transfer is not possible.
● Intercept can be programmed only system-wide. If an intercept criterion is set, for
example intercept on no answer, this feature is set for both customers.
● Up to three customers can use a system.
● Customer A and customer B cannot have the same station numbers.
● Customer A can place outgoing calls on its own trunk. Transferring an outgoing
call to customer B is possible only from a conference. However, an incoming call
can be transferred directly.
● Customer A has telephone number 02302 12345-0, STMD port 1.
● Customer B has telephone number 02302 67890-0, STMD port 2.
● Customer A has station numbers 100-109.
● Customer A has station numbers 110-119.
● Customer A is assigned the intercept position with station number 100.
● Customer A is assigned the intercept position with station number 110.
For the purpose of clarity, it is helpful to draw a diagram of the customer’s situation
like the sketch shown below:
G281-0666-01, August 2000
Hicom 150 E Office, Rel. 2.0-3.0, Service Manual 8-179