GM HEI TimingComputerInstructionManual - RABID GATOR ...

Recommendations

Info

Programming the Vacuum Advance via knob Press the knob in and rotate until the LED is lit. Notice the 10 degree timing is bright and change-able. This means the whole base curve will be advanced by 10 degrees at full vacuum. The RPM displayed is irrelevant.
Programming the Boost Retard via knob Press the knob in and rotate until the LED is lit. Notice the 10 degree timing is bright and change-able. This means the whole base curve will be retarded by 10 degrees at full boost (2BAR). The RPM displayed is irrelevant.
Page 1 and 2: GM HEI Timing Computer Instruction
Page 3 and 4: Connect the MAP sensor port shown i
Page 5 and 6: Power Up Turn on your ignition with
Page 7 and 8: 8pin GM HEI Timing Computer Instruc
Page 9 and 10: Feature Descriptions TIMING: the ba
Page 11 and 12: Download the Programming software f
Page 13 and 14: Press ‘a’ to ‘Erase Flash’
Page 15 and 16: APPENDIX A: Troubleshooting and Err
Page 20 and 21: Programming the Rev-Limiter via kno
Page 22 and 23: Saving your values via knob Press t
Page 24: APPENDIX D: Legal and Glossary of T

GM HEI TimingComputerInstructionManual - RABID GATOR ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?