GM HEI TimingComputerInstructionManual - RABID GATOR ...

Recommendations

Info

Saving your values via knob Press the knob in and rotate until the LED is lit. Notice both RPM and Timing are dim. This means nothing is change-able. If you then hold the knob in for 5 seconds you will permanently save all your Timing and RPM settings to EEPROM.
APPENDIX C: PC Programming Software all communications will take place at 38.4k baud, No Parity, 1 Start and Stop bits. Write = send parameters to RAM, the first step of applying new values. Save = copy parameters from RAM to EEPROM for permanent use.
Page 1 and 2: GM HEI Timing Computer Instruction
Page 3 and 4: Connect the MAP sensor port shown i
Page 5 and 6: Power Up Turn on your ignition with
Page 7 and 8: 8pin GM HEI Timing Computer Instruc
Page 9 and 10: Feature Descriptions TIMING: the ba
Page 11 and 12: Download the Programming software f
Page 13 and 14: Press ‘a’ to ‘Erase Flash’
Page 15 and 16: APPENDIX A: Troubleshooting and Err
Page 18 and 19: Programming the Vacuum Advance via
Page 20 and 21: Programming the Rev-Limiter via kno
Page 24: APPENDIX D: Legal and Glossary of T

GM HEI TimingComputerInstructionManual - RABID GATOR ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?