BSB 32 - sbs

INSTRUCTIONS FOR USE
BSB 32
(patented)
1. On the Coupling tool BSB 32, set the mechanical expander (E) of the desired
working diameter, checking that it has been screwed up to the stop.
STOP
NB1: In order to perform this operation, the
equipment must be in a rest position.
NB2: Check that the elastomeric adapter (F) is
mounted on the mechanical expander (E) and that no
tears or breaks are evident on the elastomeric
adapter.
The good shape of couplings is granted only if the
adapter is in a good condition (for adapter removal
and replacement, see "processing remarks").
Do not use grease, soap, lubricating or sliding
Picture 1
products of any kind on the elastomeric adapter (F).
Warning: When mounting the mechanical expander, make sure that the
equipment is not connected to the power supply source (battery or outlet).
2. Cut the pipe perpendicularly and with care, then insert the cap into it.
NB: To avoid damage to pipe heads, make sure that the shearing or pipe-cutting
blades are in good working order.
YES NO Picture 2
3. Insert the pipe into the mechanical expander (E) pushing it up to the stop.
Warning: The pipe must be in axis and parallel to the extractor.
4. Press the starting button (B) until the coupling is made (the pipe will be
automatically released from the tool once such operation is over). The
equipment is now ready for the next coupling cycle. (Wait for the shut-off valve
return time, varying from 5 to 10 seconds).
ENGLISH 13