BSB 32 - sbs

BSB 32
(patented)
COUPLING TOOL STOP DURING PROCESSING
(BLOCKED PIPE)
If the Coupling tool BSB 32 stops during the working cycle, follow these simple steps:
1) unscrew the mechanical expander (E) (even by a
few revolutions only) in order to release the pipe
as illustrated in the picture beside;
2) bring the machine back into return position;
3) lubricate the conical pin (D) with aquatechnik
grease (Item# 71391).
If the problem is not solved, send the Coupling tool
BSB 32 to aquatechnik for eventual verification and repairing.
COUPLING TOOL STOP DURING PROCESSING
In the event of machine block (the conical pin cannot
go forward or backward), see the following
instructions:
1) remove the tank cap (G) as illustrated in picture
11;
2) loosen the vent hole cap (H) by an Allen wrench
(3 mm) as illustrated in picture 12;
3) press against the rubber tank in order to let air go
out of the vent hole. When air is completely
discharged and oil starts coming out (picture 13),
close the vent hole cap (H) by the Allen wrench;
4) replace the tank cap (G). Repeat these steps, if
needed.
If the problem is not solved, send the Coupling tool
BSB 32 to aquatechnik for eventual verification and
repairing.
Picture 10
Picture 11
Picture 12
Picture 13
ENGLISH 17