Mise en page 1 - Nania

FC0823W-ICA 22/12/09 8:46 Page 10
Maintenance
Cover Removing and Cleaning
To remove the cover you will need to remove the harness buckle and shoulder straps.
Remove the harness shoulder straps with shoulder pads from the seat, the cover and head
support cushion, refer to ‘harness setting and adjustment’.
Remove crotch strap from the seat base and cover by turning the metal plate on the underside
of the seat and feeding it through the slot in the seat shell. Now remove the cover while
carefully allowing the shoulder straps to pass through the windows in the side of the cover.
Reverse this procedure to reassemble the harness and refit the cover.
When doing so check the straps are not twisted or crossed over and the metal plates are flat
against the seat surface.
The car seat cover is removable. In case of light staining, clean using a damp cloth or
soapy water. The cover can be removed completely and hand washed up to 30°.
WARNING!
TOXIC CLEANING FLUIDS CAN
CAUSE ILLNESS. NEVER USE
BLEACH, DO NOT IRON, DO NOT
MACHINE WASH, DO NOT TUMBLE
DRY AS THIS COULD DAMAGE THE
COVER AND REQUIRE REPLACING.
Buckle Removing and Cleaning
Open the harness buckle by pressing on the red button in its centre if necessary.
Remove crotch strap from the seat base by turning the metal plate on the underside of the
seat and feeding it through the slot in the seat shell.
Rinse the buckle thoroughly with warm water. Allow the buckle to dry.
Check you can hear a click when you insert the shoulder strap connectors into the buckle.
If there is no click repeat the process. Leave buckle to dry before re-assembling on the seat.
GB - User guide
WARNING!
DO NOT OIL ANY PART OF THE
BUCKLE. ALWAYS CHECK THAT
THERE IS NO FOOD DEBRIS OR
OTHER SUCH MATTER IN THE
HARNESS BUCKLE.
10
GB - User guide
GB - User guide