FR - Medisana

GB3 OperatingHeat button The heat function can be activated at any time with the shiatsu massage androlling massage, during which the vibration massage can also be activated.Press the heat button to activate the function; the LED on the control unitand the massage heads light up red. The heat is radiated through the massageheads . Press button again to de-activate the heat function; the LED andthe red light of the massage heads go out.Vibration button You can enhance the shiatsu massage at any time with a vibration massage foryour thighs by pressing the vibration massage button .The vibration massage in the upper thigh area can be operated separately.Switch on the device by pressing On/Off button .Press vibration massage button . The LED located below left illuminatesand both vibration massage motors are switched on. They begin with agentle massage. Press button again and the vibration level increases (mediumintensity massage). The LED located in the middle below illuminates. Press button a third time and the vibration level increases (highest intensity massage). TheLED located below right illuminates. After button is pressed a fourth time, thevibration massage is switched off and the LED extinguishes.Do not use the massage device for longer than 15 minutes andthen allow it to cool. Using the device for longer can overstimulatethe muscles and cause tension instead of relaxation.The massage can be finished at any time by pressing theOn/Off button.After each use, switch the device off using the On/Off button and remove the plug from the mains socket. Always storecontrol unit in its bag .To switch off the devicePress the On/Off button . The power LED begins to flash and the massageheads travel back down to the “Park” position. When this position is reached,the LED extinguishes. If you press the On/Off button while one of themassage functions is switched on, the massages in neck/shoulder and seat juststop immediately, including heat function. First the massage heads in the backtravel downwards to the “Park” position. The LED flashes meanwhile and thenextinguishes.20