Guide de Démarrage Rapide Série 2-2 - Controlnet - ASCO Numatics

More documents

Recommendations

Info

5) Communication Module Rotary Switches G2-2 Series ControlNet Quick Start Manual The Rotary switches allow the user to set the node address. Rotary Switch Settings Network Address: ! Switch Description NA 01 Sets the Ones Digits NA 10 Sets the Tens Digits Address is set to a default setting of 00 prior to shipment. Rotary switch settings do not take effect until power is cycled (turned OFF and ON). 3835052 TDG22CNQS4-0 1/07 Subject to change without notice www.numatics.com/fieldbus Page 4
6) I/O Mapping Example Example: Assumed Settings - Single Z-Boards TM used with single solenoid valves - Double Z-Boards TM used with double solenoid valves - Run Idle Header (Overhead) will always take up the first two Input words of the Input Map. Discrete I/O Configuration Pos Module Type No. Part No. In Out Bytes 1 MCM 239-1384 -- -- 2 8O Sourcing (PNP) 239-1315 1 1 3 16O Sourcing (PNP) 239-1319 1 2 4 4I Sinking (NPN) 239-1304 1 0 5 8I Sinking (NPN) 239-1308 1 0 Manifold I/O Configuration Outputs and Mapping Location Valve Outputs = 12 Word 0; Bits 0-11 Allocated Unused Word 0; Bits 12-15 Valve Outputs = 20 Word 1; Bits 0-15 Discrete Word 2; Bits 0-15 Outputs = 24 Total Outputs = 56 Word 3; Bits 0-7 Inputs and Mapping Location Discrete Inputs = 12 Word 5; Bits 0-3, 8-15 Allocated and Word 5; Bits 4-7 Reserved Inputs = 4 Total Inputs = 16 G2-2 Series ControlNet Quick Start Manual 3835052 TDG22CNQS4-0 1/07 Subject to change without notice www.numatics.com/fieldbus Page 5
Page 1 and 2: Getting Started G2-2 Series Control
Page 3: 4) Self-Test Mode G2-2 Series Contr
Page 7 and 8: G2-2 Series ControlNet Quick Start
Page 9 and 10: 10) LED Functions G2-2 Series Contr
Page 11 and 12: 12) Factory Default Settings G2-2 S
Page 13 and 14: Guide de Démarrage Rapide Série 2
Page 21 and 22: 11) Configuration avec RSLOGIX 5000

Guide de Démarrage Rapide Série 2-2 - Controlnet - ASCO Numatics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?