Manual tehnic expresoare Saeco Primea Touch Plus - Cafea

28 PROGRAMMING THE MACHINE
MILK CIRCUIT WASH CYCLE
To rinse the machine’s internal circuits used for preparing milk.
This cycle is proposed after 14 days from the fi rst dispensing of a milk-based beverage. After 14 days, the “milk
cleaning” message starts fl ashing (see page 13). Perform the wash cycle as described in this section.
Push the “milk cleaning” button and refer to the instructions below, at step 2. The machine switches to the status
described at point 7.
If the milk circuit wash cycle is not performed after 14 days, the dispensing of milk-based beverages will be still be
possible for only 7 more days. After 7 days, the wash cycle must be performed because the dispensing of milk-based
beverages is disabled. (The machine still enables dispensing hot water and coffee).
To remind the user of this important operation, the message “milk cleaning -3” is shown on the display 3 days before
the deadline and is updated on subsequent days.
Before performing this function make sure that:
1. a large enough container is at hand.
2. the milk container has been adequately cleaned of all milk residue.
3. the water tank contains a suffi cient quantity of water.
THE WASH CYCLE CANNOT BE INTERRUPTED. A PERSON MUST BE PRESENT DURING THE OPERATION.
USE ONLY AND EXCLUSIVELY THE PROVIDED DETERGENT.
1
lock
display
milk
cleaning
cycle
milk circuit
rinsing
cycle
go back
maintenance
coffee
cleaning
cycle
descaling
cycle
Select the function by
pressing the “milk cleaning
cycle” button.
back to
menu
show icon
explanation
show icon
explanation
2
milk
cleaning
milk
cleaning
-3
my custom
coffee
my custom
coffee
Open the compartment and
remove the milk container.
programming
menu
programming
menu
3
Insert the content of the
detergent packet into the
container.