Skydreamer - Carson
Skydreamer - Carson
Skydreamer - Carson
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
GB<br />
4-CHANNEL RADIO CONTROL UNIT<br />
Your almost-ready-to-fly <strong>Skydreamer</strong> set<br />
includes a 4-channel radio control unit, receiver<br />
and flight controller already installed in the<br />
<strong>Skydreamer</strong> , as well as 2 micro-servos to<br />
operate the rudder and elevator. This system is<br />
designed to have a range of 300m which means<br />
that you can control your aeroplane up to this<br />
distance. In practice, normal flying will be<br />
conducted at a closer distance in order to see the<br />
flight attitude of the model.<br />
Never start when batteries in the transmitter are<br />
weak (voltage indicator in red area) otherwise your<br />
<strong>Skydreamer</strong> could fly away out of control.<br />
Transmitter<br />
• This transmitter gives a stable and adequate<br />
output under most climatic conditions.<br />
• The frequency bands are precise and conform<br />
to internationally recognised standards. They<br />
are free from spurious radiation and therefore<br />
do not interfere with adjacent bands. For your<br />
guidance the bands are displayed on the front<br />
of the case.<br />
• Interchangeable plug-in crystals enable a rapid<br />
change of frequency by simply unplugging them<br />
from the front of the case. (A matching crystal<br />
will also be required for the receiver). The use<br />
of faulty crystals can<br />
damage the radio<br />
and invalidates<br />
our guarantee.<br />
Receiver - Changing the receiver crystal<br />
The receiver and the speed controller are built into<br />
the <strong>Skydreamer</strong> and generally require no<br />
maintenance. If you would like to fly in an area<br />
where your frequency (channel) is often used by<br />
other modellers you should buy a pair of crystals of<br />
another frequency. The crystal of the receiver is<br />
changed as detailed below.<br />
6 54321 54321<br />
Pull out the receiver's crystal and push in the new<br />
crystal. Make sure that it is fully inserted. (The<br />
crystal in the transmitter must be changed at the<br />
same time). Crystal for the transmitter (label TX)<br />
and receiver (RX) must be of the same channel.<br />
Check the functions of the radio system and<br />
servos.<br />
69<br />
RX RX<br />
10 SKYDREAMER CARSON R/C MODEL AIRCRAFT 50 050 5011