Siemens Info Line - best-in-espresso.de

LED H lights up.
● Empty the drip tray (8) and reinsert it.
The appliance rinses twice.
LED G lights up.
● Open the drawer (4).
● Drop a Siemens cleaning tablet into the
drawer (4) and close it.
● Press the start button (10).
LED D lights up.
● Fill the empty water tank (16) with lukewarm
water up to the 0.5l mark and then
dissolve two Siemens descaling tablets in
this water.
● Press the start button (10).
The service programme will now run for
approximately 10 minutes.
LED h lights up.
● Place a container with a capacity of at
least 0.5 litres under the milk frother
outlet (6).
● Pull out the milk frother (6) to open it.
The service programme will now run for
approximately 12 minutes.
LED D lights up.
● Rinse the water tank (16) and refill it with
fresh water up to the max mark.
● Press the start button (10).
The service programme will now run for
approximately 30 seconds and rinse the
appliance.
LED h lights up.
● Push the milk frother (6) in to close it.
The service programme will now run for
approximately 8 minutes.
LED H lights up.
● Empty the drip tray (8) and reinsert it.
en
If you are using a filter, reinsert it now.
The appliance has been cleaned, descaled
and is ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion.
Frost protection
¡
¡ To avoid damage caused by frost
during transport and storage, the appliance
must be completely emptied
first.
Information: The appliance must be ready
for use and the water tank (16) filled.
1. Place a large container under the milk
frother outlet (6).
2. Press the steam button (11).
LED h flashes and the appliance now
heats up for approximately 20 seconds.
3. If LED h lights up, open the milk frother
(6) by pulling it out and release steam
for about 15 seconds.
4. Press the power on/off switch O /I (9) to
switch off the appliance.
5. Empty the water tank (16) and the drip
tray (8).
35