Solar Inverter Service Software Kit - Delta Energy Systems

NOTICE
16
The "Search" function will try to communicate with all
devices connected to the bus by going through all possible
addresses from 0 to 254. The found solar inverters
will be listed below in the "Found inverters" group. The
searching can be stopped at any time by clicking the
"Finish" button. The progress of the searching process
is shown by the progress bar beside the "Finish" button.
Even only a few solar inverters are online on the bus, e.g. 3 solar inverters on address 1,
2 and 3, the search process continues until the last possible address 254. The searching
process has to be fi nished to be sure that all expected inverters on the bus are found.
After the searching process is fi nished, the found inverters are listed in the "Found inverters"
group. All the devices are preceded by a check box. The check box can become
unchecked for inverters that shall not be shown in the confi guration pane.
By clicking the "OK" button, the checked devices will be taken to the actual confi guration
and shown in the confi guration pane.
To cancel the dialog, please click on the "Cancel" button or on the red cross icon. It is not
possible to close the "Search inverters" dialog while a searching process is running. In this
case it is necessary to click on the "Finish" button at fi rst.
5.5.2 Firmware update
5.5.2.1 Single controller fi rmware update (for SI models)
This function is used to update the fi rmware of the solar inverters. Click on the
"Firmware" button to start the "Update inverter fi rmware" dialog.
It is only possible to update one solar inverter after the other. Before starting any
update, please ensure that only one solar inverter is online. If more than one
solar inverter online, the fi rmware update could cause permanently damage to
the solar inverter.