Bedienungsanleitung

BASIC OPERATIONS2. BASIC OPERATIONS2.0. SWITCH ON STBSwitch the [Device’s Main Power] switch on.When the STB is first used it will display the quick setup pagewhere the receiver can be configured quickly.For further use the STB will play the same channel as last timewhen it was switched off.? FREQUENTLY ASKED QUESTIONQ: The power of my STB is on and it is running in TV mode butthe TV screen shows nothing:A: Make sure the TV set has been set to the correct video input(not the TV channels). For example, if you have connected theSTB to the Video1 input of the TV set, then you need to selectthe corresponding Input on the TV. Mostly it is done with the AVbutton of the TVs remote control unit.Q: My STB is running in TV mode but the TV screen showsnothing except one ball and “No Signal”.A: That means the channel you selected has no signal. This canbe caused by several reasons:1. The channel you selected is not from the satellite to whichyour dish is pointing. Select another channel.2. The signal of current TV channel is too weak. You cantry to change to other channels with a stronger signal. If theproblems still exist, please consult your local dealer or installerfor technical service.3. You selected the wrong LNB type in the installation menu oryour DiSEqC switch configuration is not correct.English2.1. STANDBY1. Press [Power] button to switch from TV mode to Standbymode.2. In Standby mode press [Power] button again to switch backto TV mode. The last active channel will be showed.3. To switch off the STB complete press the main power button(placed at the rear panel of the receiver).OSD 12.2. TTX1. Press [TXT] button in TV mode to open the teletext page(OSD 1). This service is depending on the support of thechannel provider.2. If the channel does not support teletext information, it willshow “No Teletext Data” on the screen.rev 1.2PAG.15