Operation Manual Pressure Washer

PROBLEMEngine willnot start (seeEngine Manualfor furtherenginetroubleshooting)No or lowpressure(initial use)TROUBLE SHOOTING GUIDECAUSECORRECTIONNo fuel.Pressure builds up after two pullson the recoil starter or after initialuse.Choke lever in the "No Choke"position.Spark plug wire not attached.Engine ON/OFF switch in OFFpo si tion.Choke lever in the "Choke"position on a "hot" engine or anengine that has been exposed tothermal heat for a long period oftime.Fuel valve closedAdd Fuel.Squeeze gun trigger to relievepres sure.Move choke to the "Choke"po si tion.Attach spark plug wire.Place engine ON/OFF switch inON position.Move choke to the "No Choke"po si tion.Move the fuel valve lever to the"Open" position.Spray wand not in high pressure. See How to Use Spray Wandinstructions in the OperationSection.Low water supply. Water supply must be at least 5GPM @ 20 PSI.Leak at high pressure hose fitting. Repair leak. Apply sealant tapeif necessary.Nozzle obstructed.See Nozzle Cleaning instructionsin the Maintenance section.Water filter screen clogged.Air in hose.Choke lever in the "Choke" position.High pressure hose is too long.Remove and clean filter.Turn off the engine, then thewater source. Disconnect thewater source from the pump inletand turn the water source onto remove all air from the hose.When there is a steady streamof water present, turn watersource off. Re- con nect watersource to pump inlet and turn onwa ter source. Squeeze trigger tore move re main ing airMove choke to the "No Choke"po si tion.Use high pressure hose under100 feet.AWSC = Authorized Warranty Service Center15 - ENG A16637