Operation Manual Pressure Washer

OPERATING INSTRUCTIONSCompare the illustrations with your unit to familiarize yourself with the locationof various controls and adjustments. Save this manual for future reference.SprayGunMulti-AdjustableSpray WandHighPressureHoseEngineHigh Pressure Pump(located inside the shroud)BASIC ELEMENTS OF APRESSURE WASHERHigh Pressure Pump (located insidethe shroud): Increases the pressureof the water supply.Engine: Drives the high pressurepump.High Pressure Hose: Carries thepressurized water from the pump tothe gun and spray wand.Spray Gun: Connects with spraywand to control water flow rate,direction, and pressure.Multi-Adjustable Spray Wand:Allows the user to use high or lowpressure and adjusts from a pencilstream (0°) to a wide angle fanspray (40°). See How To Use Wandinstructions in this section.Chemical Hose (not shown): Feedscleaning agents into the pump tomix with the water. See How ToApply Chemicals/Cleaning Solventsinstructions in this section.BASIC ELEMENTS OF ANENGINERefer to the engine manual for locationand operation of engine controls.Choke Control: Opens and closescarburetor choke valve.Starter Grip: Pulling starter gripoperates recoil starter to crank engine.Fuel Valve Lever: Opens/closesconnection between fuel tank andcarburetor.Engine Switch: Enables and disablesignition system.PRESSURE WASHERTERMINOLOGYPSI: Pounds per Square Inch. Theunit of measure for water pressure.Also used for air pressure, hydraulicpressure, etc.GPM: Gallons Per Minute. The unit ofmeasure for the flow rate of water.CU: Cleaning Units. GPM multipliedby PSI. GPM x PSI = CU9 - ENG A16637