36" (91.4 CM) AND 48" (121.9 CM) HOOD LINER ... - Whirlpool

ABCDFEComplete Installation and CheckOperation1. Install grease filters. See the “Range Hood Care” section.2. Check operation of the range hood blower and lights. See the“Range Hood Use” section.ABCAA. White wiresB. Black wiresC. UL listed wire connectorsD. Green, bare or yellow/green wiresE. Home power supplyF. UL listed or CSA approved ¹⁄₂" (1.3 cm) strain relief3. Use UL listed wire connectors and connect black wires (B)together.4. Use UL listed wire connectors and connect white wires (A)together.WARNINGAEDA. Halogen lightsB. Halogen light switchC. Blower control switchesD. Grease filter handleE. Grease filterAElectrical Shock HazardElectrically ground blower.Connect ground wire to green and yellow ground wirein terminal box.Failure to do so can result in death or electrical shock.3. If the range hood does not operate, check to see whether acircuit breaker has tripped or a household fuse has blown.Disconnect power supply and check that the wiring iscorrect.NOTE: To get the most efficient use from your new hood liner,read the “Range Hood Use” section.NOTE: When using an In-line blower motor system, the green (orgreen/yellow) ground wire in the conduit from the In-line blowermotor system is to be connected with the green (or bare) wire ofthe home power supply cable and with the green/yellow wire (D)in the terminal box.5. Connect green (or bare) ground wire from home power supplyto the green/yellow ground wire (D) in terminal box using ULlisted wire connectors.6. Install terminal box cover.7. Check that all light bulbs are secure in their sockets.8. Reconnect power.13