Avena 248TE

- Contrast - Set the desired display contrast.
Avena 248TE
Handset settings (only available on the handset)
• Press Menu, select Settings and press OK.
• Select HS Settings and press OK.
• Select a function from the list using the navigation keys †/π and press OK.
- Select Base - Select the desired base station.
- Language - Select the desired display language.
- Auto Answer - Just pick up the handset from the base to answer a call (without
pressing any key).
- Register - Accessory handsets must be registered to the base station (see
chapter “Register new handsets”).
- De-register - Select the handset you want to deregister.
- Reset handset
Base station settings (available on the base)
• Press Menu, select Settings and press OK.
• Select a function from the list using the navigation keys †/π and press OK.
- Language
- De-register - Select the handset you want to deregister.
- Ring Priority - If several handsets are registered to your base station, all
handsets ring at the same time. You can select a single handset to ring first and
assign the number of rings (2, 4, 6 or 8 rings).
- Dial Mode - Tone: Normal dialling procedure on analog lines. Pulse: May be
required for connecting older telephone systems. Please refer to the relevant
documentation.
- Flash Time - Select the flash time for the analogue network functionalities in
your country.
- First Ring - The first ring is suppressed. The base rings only after the second
ring.
- Full ECO Mode - When Full ECO Mode is set to ON, the handset’s power transmission
is regulated and a radiation reduction is achieved when it is near the
base station.
- Manual ECO - Select the desired ECO Mode range (big/small room).
- System PIN - You can modify the PIN code (0000 on delivery).
- PBX Access - If you are connected to a PBX, you may need to enter an access
code to allow the public exchange to assign an external line for external calls.
- System Reset
Avena 248TE 83