RLT30CESA - Ryobi nářadí

More documents

Recommendations

Info

F GB D E I P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT LV SK BG ■ Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage. Move 9 m away from refueling site before starting engine. Note: It is normal for smoke to be emitted from a new engine during and after first use. WARNING Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 9 m from refueling site before starting engine. Do not smoke! 1 Litre + 20 ml = 2 Litres + 40 ml = 3 Litres + 60 ml = 50:1 (2%) 4 Litres + 80 ml = 5 Litres + 100 ml = STARTING AND STOPPING (Fig. 4a - 4b) WARNING Never start or run the engine inside a closed or poorly ventilated area; breathing exhaust fumes can kill. NOTE: Be sure to return the stop switch to the "I" (RUN) position before trying to start unit. OPERATING THE TRIMMER (Fig. 5) Hold the trimmer with the right hand on the rear handle and the left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip height. Always operate trimmer at full throttle. Cut tall grass from the top down. This will prevent grass from wrapping around the shaft housing and bump head which may cause damage from overheating. If grass becomes wrapped around the bump head, stop the engine, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in lubricant dripping from the silencer. CUTTING TIPS (Fig. 6) ADVANCING THE LINE (Fig. 7) For Reel Easy TM Only English 13 MAINTENANCE WARNING Use only original manufacturer's replacement parts, accessories and attachments. Failure to do so can cause possible injury, poor performance and may void your warranty. ■ You may make adjustments and repairs described here. For other repairs, have the trimmer serviced by an authorized service agent. ■ Consequences of improper maintenance may include excess carbon deposits resulting in loss of performance and discharge of black lubricanty residue dripping from the muffler. ■ Make sure all guards, straps, deflectors and handles are properly and securely attached to avoid the risk of personal injury. ■ For RLT30CES only: the cutting attachment must not work in idle mode. If this requirement is not satisfied, the clutch has to be adjusted or the machine needs an urgent maintenance by a qualified technician. LINE REPLACEMENT (Fig. 8) For Reel EasyTM Only CLEANING THE EXHAUST PORT AND MUFFLER Depending on the type of fuel used, the type and amount of lubricant used, and/or your operating conditions, the exhaust port and muffler may become blocked with carbon deposits. If you notice a power loss with your petrol powered tool, a qualified service technician will need to remove these deposits to restore performance. SPARK ARRESTOR The spark arrestor must be cleaned or replaced every 25 hours or yearly to ensure proper performance of your product. Spark arrestors may be in different locations depending on the model purchased. Please contact your nearest service dealer for the location of the spark arrestor for your model. CLEANING THE AIR FILTER SCREEN (Fig. 9) FUEL CAP WARNING A leaking fuel cap is a fire hazard and must be replaced immediately. SPARKING PLUG (Fig. 10) This engine uses a Champion RCJ-6Y or equivalent spark plug with 0.63 mm electrode gap. Use an exact replacement and replace annually. STORAGE (1 MONTH OR LONGER) <strong>RLT30CESA</strong>.indd 13 2009/2/10 5:03:16 PM
F GB D E I P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT LV SK BG ■ Drain all fuel from tank into a container approved for fuel. Run engine until it stops. ■ Clean all foreign material from the trimmer. Store it in a well-ventilated place that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts. ■ Abide by all ISO and local regulations for the safe English TROUBLESHOOTING 14 storage and handling of fuel. Excess fuel should be used up in other 2-stroke engine powered equipment. IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER. PROBLEM POSSIBLE CAUSE SOLUTION Engine will not start. Engine starts but will not ac cel er ate. Engine starts but will only run at high speed at half choke. Engine does not reach full speed and emits ex ces sive smoke. No spark. No fuel. Engine is flooded. Starter rope pulls harder now than when new. Engine requires approximately three minutes to warm up. Carburetor requires adjustment. 1. Check lubricant fuel mixture. 2. Air filter is dirty. 3. Spark arrestor screen is dirty. Check spark. Remove spark plug. Reattach the spark plug cap and lay spark plug on metal cylinder. Pull the starter rope and watch for spark at spark plug tip. If there is no spark, repeat test with a new spark plug. Push primer bulb until bulb is full of fuel. If bulb does not fill, primary fuel delivery sys tem is blocked. Con tact a servicing dealer. If prim er bulb fills, engine may be flooded, proceed to next item. Remove spark plug, turn unit so spark plug hole is aimed at the ground. Rotate the choke dial to “ ” position and pull starter cord 10 to 15 times. This will clear excess fuel from en gine. Clean and reinstall spark plug. Pull starter three times with choke dial at “ ”. If en gine does not start, rotate choke dial to “ ” position and repeat normal starting pro ce dure. If engine still fails to start, repeat pro ce dure with a new spark plug. Contact a servicing dealer. Allow engine to completely warm up. If engine does not accelerate after three minutes, contact a ser vic ing dealer. Contact a ser vic ing dealer. 1. Use fresh fuel and the correct 2-stroke lubricant mix. 2. Clean air filter. Refer to Clean ing the Air Filter Screen earlier in this manual. 3. Contact a servicing dealer. <strong>RLT30CESA</strong>.indd 14 2009/2/10 5:03:16 PM
Page 1 and 2: RLT30CESA F COUPE-BORDURES MANUEL D
Page 3 and 4: Sous réserve de modifications tech
Page 5 and 6: F GB D E I P NL S DK N FIN GR HU CZ
Page 15: F GB D E I P NL S DK N FIN GR HU CZ
Page 67 and 68:
F GB D E I P NL S DK N FIN GR HU CZ
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
GR F GB D E I P NL S DK N FIN HU CZ
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
F GARANTIE LIMITÉE TTI garantit ce
Page 211 and 212:
NL BEPERKTE GARANTIE TTI garandeert
Page 213 and 214:
RU ОГРАНИЧЕННАЯ ГАР
Page 215 and 216:
LT RIBOTA GARANTIJA LV TTI garantuo
Page 217 and 218:
F GB DÉCLARATION DE CONFORMITÉ CE
Page 219 and 220:
DK N CE-OVERENSSTEMMELSESERKLÆRING
Page 221 and 222:
PL SLO DEKLARACJA ZGODNOŚCI CE Oś
Page 223 and 224:
BG ÑÖäãÄêÄñàü áÄ ëöé
show all

RLT30CESA - Ryobi nářadí

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?