CoolAir RT880, SP950 - Waeco

InstallationCoolAir RT880, SP9506.3.4 Menu level 3: Operating modeThe unit always starts with a defined operating mode for room temperature.This parameter can be configured:➤ Start configuration mode (chapter “Starting and ending configurationmode” on page 44).✓ The first digit of the display (fig. 0 5,page 9) shows the menu leveland the second and third show the parameter which can be set.➤ Press the + button (fig. 0 6,page 9) twice to switch to menu level 3.➤ Press the Operating Mode button (fig. 0 4,page 9) to change theparameters.✓ The digits in the display flash until the parameter you entered isconfirmed.➤ Use the + and – buttons (fig. 0 6 and 7, page 9) to set the mode withwhich the unit starts up:Characteristic figureOperating mode0 Automatic mode1 Operating mode 12 Operating mode 23 Operating mode 3➤ Press the Operating Mode button (fig. 0 4,page 9) to confirm yourentry.✓ The set value is saved and is then used when the unit is restarted.✓ You are now in menu level 3 again and can use the + and – buttons toswitch between menu levels.6.3.5 Menu level 4: Default settingYou can reset the parameters you set in configuration mode on menulevels 1 to 3 to the default settings:➤ Start configuration mode (chapter “Starting and ending configurationmode” on page 44).✓ The first digit of the display (fig. 0 5,page 9) shows the menu leveland the second and third show the parameter which can be set.➤ Press the + button (fig. 0 6,page 9) three times to switch to menulevel 4.✓ The digital display shows --.46EN