RLT3725CH-A / RLT3725-A - Ryobi

More documents

Recommendations

Info

F GB E I P NL S DK N FIN GR TR EST LT LV OPERATION left, left to right with the line parallel to the ground and proceeding forward slowly. Keep the trimmer inclined by about 30°. ■ On RLT3725CH-A model, you can put your arm on the crutch to achieve a more comfortable position. ■ High grass should be cut in layers, always begin from the top. The cuts should be short. ■ Do not cut damp or wet grass. Dry grass will give excellent results. ■ Always let the line rotate at top speed. Do not work in such a way as to overload the trimmer. ■ Avoid wearing the line out quickly by knocking against hard objects (stones, walls, fences etc.). ■ Never pass the line trimmer over the electric cable while the line trimmer is running; make sure the cable is always in safe position behind your back. ■ To switch off the line trimmer, simply release the trigger. CAUTION After switching off, the nylon line will continue to rotate for a few more seconds. CUTTING TIPS Lawn Edging (Fig. 7) When the trimmer is used for lawn edging, pull the rotating release (12) and rotate the trimmer head 180 º. Adjustable angles (on RLT3725CH-A only) (Fig. 8) On RLT3725CH-A model, press on the foot pedal (14) and the trimmer head (13) can be turned to achieve different angles for cutting less accessible or more awkward places. Five different angles can be selected. SAFETY GUARD LINE TRIMMING CUT-OFF BLADE This trimmer is equipped with a line trimming cut-off blade on the safety guard. For best cutting, advance fresh lines by gently tapping the bump head (19) on the ground. Fresh lines will be released from the bump head and trimmed to optimum length by the cut-off blade. Advance line whenever you hear the engine running faster than normal and when it is apparent the line is worn or broken. This will maintain best cutting performance. English 14 MAINTENANCE REPLACING THE CUTTING LINE WARNING Use of line other than the original 1.4 mm. monofilament cutting line could cause serious personal injury or damage to the trimmer. WARNING Make sure the trimmer head stops rotating when you release the trigger. Contact with a rotating trimmer head could cause personal injury. ■ Unplug the trimmer. ■ Press in both lock tabs (in between the line eyelets), then remove the spool cover (Fig. 9). ■ Remove the empty spool and replace with a new spool (Fig. 10). ■ Insert the lines into the eyelets on the bump head. ■ Replace the spool cover securely (Fig. 11). ■ Press the bump button (17) and advance the line manually until it can be trimmed to length by the cut-off blade.
F GB E I P NL S DK N FIN GR TR EST LT LV English TROUBLESHOOTING Problem Possible cause Solution Line will not advance when 1. Line is welded to itself. 1. Lubricate with a silicone spray. tap bump button 2. Not enough line on spool. 2. Install more line (Refer to "Replacing the Cutting Line" earlier in this manual). 3. Line is worn too short. 3. Pull lines while alternately pressing down on and releasing bump button. 4. Line is tangled on spool. 4. Remove line from spool and rewind (Refer to "Replacing the Cutting Line" earlier in this manual). Bump head is hard to turn Grass wrapped or built up Clean affected parts of the machine. around head. Grass wraps around the Cutting tall grass Cut tall grass from the top down. attachment shaft and the at ground level. trimmer head assembly DISPOSAL Waste electrical products should not be disposed of together with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. 15
Page 1 and 2: RLT3725CH-A / RLT3725-A F GB E I P
Page 3 and 4: 2 6 1 1 2 Fig. 4 Fig. 8 2 180° Fig
Page 5 and 6: Attention ! Il est indispensable qu
Page 7 and 8: F GB E I P NL S DK N FIN GR TR EST
Page 19: F GB E I P NL S DK N FIN GR TR EST
Page 71 and 72:
F GB E I P NL S DK N FIN GR TR EST
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
I DICHIARAZIONE DI GARANZIA LIMITAT
Page 123 and 124:
GR ΠΕΡΙΟΡΙΣΜΕΝΗ ΕΓΓ
Page 125 and 126:
F GB E I P NL S DK Niveau de puissa
Page 127 and 128:
DK N IN GR CE-OVERENSSTEMMELSESERKL
show all

RLT3725CH-A / RLT3725-A - Ryobi

Create successful ePaper yourself

Delete template?

Save as template?