Manual Mecmar mobiltork - Andersson & Henriksson

7 Assembly after transport
7.1 Models with diameters from 3 to 4.5 meters (D - SSI - S - F )
Montering efter transport
Keep to the following instructions when, for transport reasons, the drier is dismantled at
the factory according to point 6.3.b (into small parts) and the customer himself wants to
perform reassembly.
This task must be performed by personnel with knowledge of elementary mechanics.
Perform unloading and assembly work on a flat yard and distant from obstacles and
impediments.
7.1.1 Necessary equipment
The following equipment is necessary to assemble the drier:
- a hoist designed to lift 5,000 Kg.
- a compressor with screw tightener
- a set of wrenches
Connection materials (bolts and washers) are listed in the description of the various
assembly phases, in the diagram and in the list that accompanies the machine.
7.1.2 Assembly phases for drier MODELL S34/255T
A) Refer to Fig.5. Set frame (1) so that its feet are resting on the base frame. Level
the frame.
B) Install base cone (2) inside the base and install side supports 1.1-1.2-1.3 and
rear reinforcing composed of winch support (14). Then connect angle irons (15)
between base cone and base.
C) Install uprights (3 - Fig.6) marked with the letters B-C-D on their flat plates
welded to the base using: No.4 M14x50 bolts, No.8 flat washers, No.4 split
washers, 4 M14 nuts (bring them together without tightening them.
Connect uprights (3) to base cone (2), without tightening the connections, using
the following bolts: No.4 M14x30, No. 4 M14 self-locking nuts.
D) Install mixer (4) on the thrust bearing placed below inner basket (5) as in Fig.7.
E) Position inner basket (5-Fig. 8) after installing cone (6) inside the base cone.
Fasten it to the 3 uprights B-C-D with 4 M12x40 screws, 8 flat washers, 4 split
washers, 4 M12 nuts without tightening them.
28