Manual Mecmar mobiltork - Andersson & Henriksson

7.2.4 Connecting the dust aspiration system
Montering efter transport
This system is the last part of the plant to be installed.
The assembly procedure is illustrated on Page "5". Parts are specified as follows:
13) No. 4 dia. 150 tube clips
14) No. 2 tubes, dia. 150, length 450
14a) Y reducer diameter 150/150/200
15) No. 1 flexible tube diameter 200, l = 6 m
16) No. 2 support rings, dia. 230
17) No. 3 bands for dia. 200 tubes
18) No. 1 90°elbow dia. 200
19) No. 3 collars dia. 200
20) No. 1 aspirator
21) No. 1 aspirator motor
22) No. 1 tube dia. 200
23) No. 1 tube dia. 200, l = 100
24) No. 1 flexible tube, dia. 200, l = 3 m.
The electric fan is fastened to the top part of the boiler where anchor brackets are
already provided. The tube that the electric fan supply cable passes through must be
fastened to the bolts provided on the side of electric board "E" and "F". Then
connect pin "G" to the switched outlet that comes from the alternator.
44