Manual Mecmar mobiltork - Andersson & Henriksson

Montering efter transport
7.2.3 Assembly phases
A Position the body of the heat generator in the front part of the cylinder and combine
the parts marked with the same numbers as indicated on Page 3.
The operation indicated by the number "1" must be performed by the worker
from inside the drier, entering through the tapered door “3” situated on the base
come (lower part of the drier) and trough the flanged tube. Fasten the front part of
the heat generator using 16 M10x30 bolts, 16 split washers and 16 M10 nuts.
B Replace the refill plug on the inner reduction unit that drives the scraper with a plug
equipped with a relief valve. This plug prevents oil from exiting from the reduction
unit when it heats up. It was necessary when the drier was horizontal for transport
purposes.
C For the operation indicated by the number "2" use No. 10 M12x30 bolts and No. 8
dia. 12 split washers.
D Insert air temperature monitoring and control probe "A" in the tube that goes inside
the internal heat diffusion basket and make sure it is properly inserted, that it will not
be damaged and that it juts out inside the chamber.
E Insert product temperature probe "B" in the plate fastened to the screen. VARNING:
a twin-taper device is used to fasten this probe and only needs to be very lightly
tightened. Too much tightness could damage the heat-sensitive element inside the
sensor. Check that the guard that protects the top part of the probe against falling
products is installed.
F Install the front support foot simultaneous with the drawbar using No. 8 M14x50
bolts and relative split washers.
G Connect folding discharge tube "6" to fixed tube "6" through the already-assembled
pin on Page "4".
H Connect cable "D" to ring "7" placed on the short rod and run it through ring "8" on
the long rod and then inside tube "9" placed on the profiled ring until it reaches winch
"10" where it is connected using a preinstalled clamp. Comply with the following
schema for fastening the cable.
I Connect hopper "11" to the fixed loading tube through pin "12", Page "5".
Connect the cardan shafts:
"H" to the recycle screw
"I" to the loading screw.
40