TeeJet LH500 IntelliTram Fit Instructions (in English)

8
LH AGRO
7
8
1
2
5 6
3
4
10
13
12
11
9
14
15
16
2408-0014
Fitting the monitor (4):
Fit the monitor on the right-hand side of the cab at a suitable height and distance .
Connecting the 3-pin power plug (7):
If the tractor is fitted with a 3-pin power socket, the following are normally available:
+12V power (15/30)
0V power ( 31)
+12V electronic (82), On/off via the ignition key
The 3-pin power plug must always be connected as the outputs are supplied via this
plug. The monitors electronics are supplied via the small pin in the plug.
A “power box” can be supplied as an optional extra if the tractor is not fitted with a 3pin
power socket (LH no. 901-100):
0
1
Fit the ”power box” in the tractor cab and connect to the tractor’s battery. The
system is switched on and off with the power switch.
Connecting the 7-pin DIN/ISO plug (8):
The following signals are normally available if the tractor is fitted with a 7-pin
DIN/ISO socket:
No. 1: Forward speed -Radar (if fitted).
No. 2: Forward speed -wheel (Sensor in the gearbox).
No. 4: Area on-off.
No. 6: +12V
No. 7: 0V (Ground)
It is not necessary to use the 7-pin DIN/ISO plug.
Fitting the implement socket (9):
Fit the implement socket at the rear of the tractor using the supplied bracket.
UK