S 004 - Ebike

If all the 5 LEDs do not light up, PanTerra
recommends that you first charge the battery
fully.
To do this, connect the drive battery to the
charging device included in the scope of
delivery. Refer to the Chapter “Charging and
care of the battery”.
Lithium-ion batteries get self-discharged
much slower than Nickel batteries and
can therefore be stored for approximately
6 months without recharging. However,
if the battery is not recharged after this
period, the chemical structure can be
damaged, which affects the performance
of the battery considerably and can make
it unusable.
The compartment for the battery-fuse is located
on the side. (cover with symbol ).
Insert the Pedelec’s drive battery into the
acceptor depression (as shown in Figures).
Ensure that the fixture bar slides down and
catches below the fixture stay.The battery is
then locked with the closeable latch lock.
The battery should now be firmly positioned in
the support slot as demonstrated in figure.
Locking the battery ensures that it is firmly held
so that damage caused through vibration is
prevented; thereby guaranteeing that optimal
electrical contact is maintained between the
battery and the electronics of the Pedelec.
44