Bedienungsanleitung MADMAXX MULTI TAUCHKREISSÄGE

TM
– Rotate and tighten the nut (6) with a suitable
tool clockwise to the screw (13).
Install the parallel limit stop
– ☞ Install/set up the parallel limit stop –
Page 21.
Connect the vacuum cleaner
WARNING
Risk of injury!
When working with the device, always
connect an appropriate vacuum cleaner.
CAUTION
Damage to device!
The suction nozzle (8) can only go in one
position into the device.
– Lock the suction nozzle (8) at the end of the
intake of the suction hose (9).
– Turn slightly the suction nozzle (8) against the
intake of the suction hose (9) until it clicks into
place.
– Lock the adapter (17) on the other end of the
intake of the suction hose (9).
– Turn slightly the adapter (17) against the
intake of the suction hose (9) until it clicks into
place.
Operation
WARNING
Risk of injury!
In the event of malfunctions, release
immediately the On/Off switch (12) and
disconnect from the mains.
Check before you start!
WARNING
Risk of injury!
The device may only be operated if there
is no defect or error. If a part is defective,
it must necessarily be replaced before
the next use.
Check that the device is safe to use before
turning the power on:
– check whether there is any visible defect or
error.
– check whether all parts are firmly fixed onto
the device.
– check whether the safety devices are in good
working order.
– check whether the saw blade can operate
freely.
– Introduce the suction nozzle (8) in the opening
of the device until it clicks into place.
Set the cutting depth
WARNING
Risk of injury!
Before working on the device, always
unplug it from the mains (device without
power).
20