Bedienungsanleitung MADMAXX MULTI TAUCHKREISSÄGE
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
EN<br />
Notice:<br />
Please make sure that the correct depth is<br />
set for the saw blade depending on the<br />
material (☞ Operating instructions– Page<br />
22).<br />
– Open the lock on the cutting depth limiter (5).<br />
– Set the cutting depth limiter (5) on the desired<br />
cutting depth.<br />
– Close the lock on the cutting depth limiter (5).<br />
Notice:<br />
For a better handling of the device, a press<br />
button is integrated to the On/Off switch (12).<br />
Turn the device on and press the button.<br />
– Release the On/Off switch (12).<br />
Turning the device on/off<br />
WARNING<br />
Risk of injury!<br />
Before cutting, wait until the blade has<br />
reached its maximum speed.<br />
Notice:<br />
The device is fitted with an overload<br />
protection. If the indicator light (11) starts to<br />
flash, reduce the feed force with which you<br />
push the device through the work piece.<br />
If the indicator light (11) lights up<br />
continuously and the device has stopped,<br />
the overload protection has switched the<br />
device off. Either the feed force was too<br />
high or the saw blade was blocked by a<br />
foreign body in the work piece. In both<br />
cases, turn the device off and check the<br />
work piece for foreign bodies and the saw<br />
blade for damage.<br />
If you do not find any foreign body in the<br />
work piece, you may resume your work at<br />
reduced feed force.<br />
– slide the On/Off switch (12) backwards.<br />
Assemble/set up the parallel limit stop<br />
Notice:<br />
The parallel limit stop can be used for<br />
precise cutting of the work piece.<br />
The parallel limit stop can be assembled<br />
on the device from both sides. The length<br />
specification on the parallel limit stop is<br />
only an approximate dimension.<br />
– Loosen fixing screws (3).<br />
– Guide the parallel limit stop (18) through the<br />
opening guides (4).<br />
21