Test & Measurement Lexikon - Triax

Test & Measurement Lexicon
Lexicon
Basic information
The products are designed, tested and marked according to IEC
The multipart international standard IEC 61010 corresponds with
61010. These products bear a text indicating the permissible rated
the EN 61010 standard as well as the VDE regulation 0411.
voltage and measurement category. SKS products meet international
The aim of the standard IEC 61010 is to protect the user against the
safety standards and are recognized all over the world as reliable
following dangers through suitable structures (e.g.):
and high-quality products.
• Dangerous electrical currents for the human body
• Electrical burns
• Mechanical dangers
Safety instructions
• Excessively high temperatures
The rated values stated by SKS are only valid, if the user applies
The provisions of IEC 61010 relate to reliable functioning, efficiency
and other characteristics of the devices, as well as the maintenance
of the same shall be applied to the following devices:
• Measuring and testing devices
• Control and regulation devices
• Laboratory devices
• Measuring accessories for the above mentioned devices
What does IEC 61010 mean for SKS Test & Measurement
products?
As a leading supplier of electro-mechanical components,
SKS offers products and measurement accessories according to IEC
61010.
Our products are designed for voltages from 30 VAC / 60 VDC to
1000 V AC/DC. Voltages above 30 VAC / 60 VDC may lead to
dangerous currents for the human body. For this, SKS offers the 2
mm & 4 mm safety system.
If used correctly, a large range of the products ensures optimum
safety up to 1,000 V.
and/or installs the measurement accessories according to the regulations.
We also want to note that the safety eventually is the responsibility
of the user of Test & Measurement products, as the qualified
measurement accessory will be actually used for his purposes according
to regulations.
Technical details
We reserve the right to make changes with regard to technical
enhancements and for higher safety without prior notice. All the
details contained in the catalogue are not guaranteed.
Tensile force, pull relief
Safety measuring leads according to IEC 61010 are crimped, soldered
or welded and they are being provided with pull relief at the
conductor as well as the conductor insulation. Therefore, the safety
measuring leads are exceptionally robust and made to last.
14 SKS Kontakttechnik GmbH | Neue Schichtstraße 14 | D-09366 Niederdorf | Telefon +49-37296-930-300 | Telefax +49-37296-930-301 | www.sks-kontakt.de