Download ... - Horizon Hobby
Download ... - Horizon Hobby
Download ... - Horizon Hobby
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
7-1-4 Speed<br />
Programming of the Servo Speed function will be done in<br />
this menu.<br />
7-1-5 Absolute Travel<br />
7-2 Dual Rate and Exponential<br />
Dual Rate and Exponential functions are available for<br />
Aileron, Elevator and Rudder. You can assign these<br />
functions to different switches.<br />
Dual Rate<br />
Affects the overall travel which in turn affects control<br />
response sensitivity equally throughout the range of that<br />
channel. Reducing the dual rate reduces the maximum<br />
control rate as well as overall sensitivity.<br />
Exponential<br />
Affects the sensitivity around center but has no affect on<br />
the overall travel. Positive Exponential reduces control<br />
sensitivity around neutral for more precise control but<br />
does not affect the maximum control response.<br />
Note: Positive and negative exponential values are<br />
available. A positive expo value reduces control<br />
sensitivity around center. It does not affect maximum<br />
travel and is recommended. Negative exponential values<br />
increase sensitivity around neutral and is seldom used.<br />
7-3 Throttle Cut<br />
The Throttle Cut function allows you to shut an engine<br />
off with all assigned switches and tip switches on sticks<br />
except: Pot1, Pot2, Pot3 and Pot 4. In the Throttle<br />
menu, you can program the Gas Position, assign it to<br />
a switch and set a delay up to 5 seconds. Release the<br />
programmed throttle cut switch, and normal throttle<br />
operations resume.<br />
SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL<br />
7-1-6 Balance<br />
In the display, you can choose the following parameters<br />
with the Roller:<br />
• Channels: Aileron, Elevator and Rudder<br />
• Curve: If the function is not assigned to a switch, only<br />
one curve is available. Dual Rate is not changeable<br />
with the Stick in the Off Position. Rate at 100%<br />
Exponential is not changeable if the Switch is Off. Expo<br />
at 0%<br />
• Switch On Position<br />
These parameters are adjustable: Channel, Dual Rate,<br />
Exponential<br />
You can assign 3 different Curve, Expo and Dual Rate<br />
values to a three-position switch and activate them<br />
via flying. You can choose any switch you wish to<br />
program. The switches keep their programmed values<br />
until you change them. If you assign stick tip switches,<br />
programmed values change only when the switch is<br />
pushed.<br />
13<br />
EN