Tischkreissäge ATS 250 Circular Saw Bench ATS 250 Scie - Atika
Tischkreissäge ATS 250 Circular Saw Bench ATS 250 Scie - Atika
Tischkreissäge ATS 250 Circular Saw Bench ATS 250 Scie - Atika
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
Possible faults<br />
Fault Possible cause Removal<br />
Machine fails to start after<br />
switching on or switches off<br />
during idle running<br />
• Power failure<br />
• Extension cable defect<br />
• Motor protecting switch has tripped –<br />
right LED on the control panel is flashing.<br />
• Motor or switch defect<br />
• <strong>Saw</strong> blade sticks<br />
Machine stops while cutting • <strong>Saw</strong> blade blunt<br />
• Feed too large<br />
Workpiece sticks when<br />
feeding<br />
• <strong>Saw</strong> blade blunt<br />
• The longitudinal or parallel stop is not<br />
parallel to the saw blade, see P. 14-15<br />
Burn marks at the cut edges • <strong>Saw</strong> blade is unsuitable for the cutting<br />
task or blunt<br />
Chip exit blocked • No exhaust suction connected<br />
• Suction too weak<br />
17<br />
• Replace fuse<br />
• Check cable, no longer use defect cable<br />
• Switch motor back on after cooling<br />
”Motor protection”, P. 14<br />
• Have motor or switch checked by an approved<br />
electrician or replaced by original spare parts<br />
• Remove the cause of the jam.<br />
• Replace saw blade<br />
• Allow the motor to cool off and then continue work<br />
using less pressure<br />
• Hold the workpiece firmly and switch the motor off<br />
immediately. The have the saw blade sharpened or<br />
renew<br />
• Readjust the scale, see P.14-15<br />
• Replace saw blade or have it sharpened<br />
• Switch off saw and remove chips<br />
• See “Safe working”
Change language