INN-FORM Plus Manual - Call Accounting Software

Put these keystrokes in the order that they will occur. Once you
have this information in front of you, inputting the keystrokes in
logical sequence into the system will be easy.
There are six different Multiple Reports which can be defined.
Each report represents a block of 45 keystrokes which can be used
to select reports and their parameters. Each Multiple Report can
then be generated, as previously defined, by pressing MULTIPLE
REPORTS and entering the Multiple Report number (1-6).
The six different Multiple Reports that can be chained together (for
a possible 270 keystrokes). To chain the Multiple Reports together
use the last keystrokes in one Multiple Report to call up or activate
another Multiple Report. Higher report numbers have priority, and
therefore can be used as "subroutines". See the example below for
more detail on how this works.
The individual reports that are programmed into a Multiple Report
can be programmed to loop on a range of numbers and produce
several reports instead of just one. This is done by including
Function 27 and its required parameters in the definition of the
Multiple Report. For more information on the Universal Number
Loop refer to Function 27.
Entering a 0 clears all the defined Multiple Reports. Entering a dash
in front of a Multiple Report number (1 through 6) will indicate you
wish to define that Multiple Report. The CANCEL key is used to
save a definition and the DELETE key will erase an incorrect
keystroke made during the definition input.
ƒ To define each major report (1 through 6):
STEP 1. Press MULTIPLE REPORTS. The system will display,
"REPORT #".
STEP 2. Enter a dash (-) and the number of the report that you
wish to define (1 through 6).
STEP 3. Press ENTER.
STEP 4. The system will display, ":_". Enter the keystrokes
necessary to produce the reports, with the parameters you
previously defined.
INN-FORM Plus REFERENCE 2-24