Hauptkatalog - LED Linear

27/08/2012
The lacquer APL of the company Electrolube www.electrolube.
com has fulfilled the conditions for VarioLED Flex in our
tests.
• VarioLED Flex can be cut with a pair of scissors at marked
locations according to the datasheet.
• Easy assembly and installation is facilitated by means of the
double sided adhesive on the back-surface of VarioLED
Flex. Pay attention to provide a clean and dry mounting
surface, free of oils, silicones and dirt particles. The mounting
surface must have sufficient structural integrity. LED
Linear assumes no liability for the bonding of VarioLED
Flex because of different applications, environmental conditions
and surface properties. If necessary use additional
fixing or installation.
• To ensure an optimal bonding VarioLED Flex should not be
stored for longer than 12 months at 20°C and up to 50%
relative humidity (in packed condition)
• Solder connections should only be performed on designated
solder pads (marked with “24 V 2 ”). The maximum solder
time of 10 seconds and the maximum soldering temperature
of 260°C must not be exceeded during soldering. The minimum
bending radius is 2 cm. VarioLED Flex may be bent
LED Linear – linear lighting solutions
over a smaller radius but only in areas containing no electronic
components. Such bending should be made only
once and fixed in position.
• In case of assembly on metallic or other conductive
surfaces, an electrical isolation between soldering points
and mounting surface is necessary.
• VarioLED Flex HERCULES, ZEUS, RGB-S, RGB-L and RGB SV
have to be electrically isolated on the rear side before
mounted on an electrically conductive surface.
• VarioLED Flex shall only be mounted on surfaces that
provide sufficient cooling.
• Ensure sufficient ventilation and heat transfer from the
product to the ambient
• The thermal length expansion coefficient is 17*10^–6/K.
When installing in environments with large variations in
temperature (e. g. outdoor applications) and operating
length of more than 2 m, the use of metallic mounting surfaces
is necessary. Otherwise it is advisable to use an additional
thicker adhesive tape to absorb the stress of any
mismatch in expansion coefficients.
• The maximum cable length from power supply to the
VarioLED Flex product can be taken from the tables on
page 340 ff.
329