ISO/TC 108/SC 3 N 388-CEN/T C 231 N 439

Date: 2003-07 ISO/TC 108/SC 3 N 388-CEN/TC 231 N 439
Report of voting on doc. 108/3 N 367-CEN/TC 231 N 402
Second ISO/CD 8041 "Human response to vibration - Measuring instrumentation"
1 2 (3) 4 5 (6) (7)
Comment (justification for change) by the MB Proposed change by the MB Secretariat observations
on each comment submitted
Type
of
comment2
Paragraph/
Figure/Table/
Note
(e.g. Table 1)
Clause No./
Subclause No./
Annex
(e.g. 3.1)
MB 1
f1 × 10 1/10 < f < f2 × 10 –1/10
f2 × 10 –1/10 ≤ f ≤ f2 × 10 3/10
f2 × 10 3/10 < f
DE 05.09 ed below eq. (12): replace amplitude with magnitude Accepted – however clause
5.9 and 5.10 have been
totally replaced by a new
signal burst response clause
DE 05.09 ed below eq. (13): replace amplitude with magnitude Accepted – See comment on
05.09
Accepted – See comment on
05.09
DE 05.09 2nd para ed read: Table 5 gives the responses to a single tone-bursts
for...
DE 05.09 4th para ed delete the word reference Accepted – See comment on
05.09
DE 05.09 note ed no shall in a note! read: ...given in Table 5 shall apply... Accepted – See comment on
05.09
DE 05.10 ed below eq. (14): replace amplitude with magnitude Accepted – See comment on
05.09
DE 05.11 5th para ed 1st line read indicator
Accepted
last sentence: replace meter with indicator
DE 05.14 1st para ed 3rd line delete time Accepted
DE 07.6 3rd para te acc. to 11.21.8 we use the ref. freq. rather than 1 kHz Accepted
DE 07.6 last but 1 pa ed replace shall be apply with applies Comment accepted – have
chosen to delete the word
“be”
Accepted
DE 07.6 note ed read: this International Standard
delete for each type of amplitude modulation, we defined
only one!
1 MB = Member body (enter the ISO 3166 two-letter country code, e.g. CN for China; comments from the ISO/CS editing unit are identified by **)
2 Type of comment: ge = general te = technical ed = editorial
NOTE Columns 1, 2, 4, 5 are compulsory.
page 3 of 25
ISO electronic balloting commenting template/version 2001-10