Comfort 830 - Marantec
Comfort 830 - Marantec
Comfort 830 - Marantec
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6. Mounting<br />
6.3.1 / 4<br />
• Joint he toothed rack segments until the required<br />
measurement (q = door length - approx. 160 mm)<br />
is reached.<br />
In case the segments are longer than the necessary<br />
length:<br />
• Cut the projecting part.<br />
6.3.1 / 5<br />
q<br />
• Slide the toothed rack segments into the toothed<br />
rack segment profile.<br />
6.3.1 / 6<br />
• Insert the end position damper (A) and the clamping<br />
device (B) into the toothed rack profile.<br />
6.3.1 / 7<br />
B A<br />
Attention!<br />
The toothed rack segments must have<br />
a slight tension in the completely<br />
mounted toothed rack.<br />
Otherwise malfunction and damages<br />
to the toothed rack could result.<br />
To mount the second end position damper:<br />
• Press the clamping device (B) into the profile until the<br />
toothed rack segments (C) are under slight tension.<br />
• Mark the two drill points of the clamping device on<br />
the profile.<br />
Installation and operating instructions <strong>Comfort</strong> <strong>830</strong> GB (#70676)15<br />
B<br />
C