Comfort 830 - Marantec

9. Programming
9.1.2 Reference point
The following is displayed:
In operating mode
The LED shortly lights up when the reference
point is passed
In programming mode
Advice:
The control unit can only be
programmed when the reference point
has been passed electrically.
Therefore the door has to be travelled
1x to the end position OPEN and 1x to
the end position CLOSED before first
programming.
The operator is between the reference point
and the end position OPEN.
The operator is between the reference point
and the end position CLOSED.
9.1.3 Setting the door positions
The programming of the "end position OPEN" and
"end position CLOSED" can be carried out in two ways:
1. Coarse adjustment by permanently holding
a button
The setting is carried out when button + or - is pressed
permanently.
The door travels correspondingly to the OPEN or
CLOSED position.
2. Fine adjustment by a short button impulse
The setting is carried out by a short button impulse
on button + or -. The door does not move during this
procedure.
Every time the button is pressed the end position is
shifted by 4 mm to the respective direction.
To test the end position, the door has to be traveled
over the reference point to the OPEN position or to the
CLOSED position.
During the button impulse the LED 7
is flashing quickly.
Advice:
The control unit travels without
press-and-release.
Legend:
LED off
LED on
LED flashing slowly
LED flashing quickly
Installation and operating instructions Comfort 830 GB (#70676)31