05.03.2013 Views

9362705b, Operating Manual UFD 170 DVB-S Receiver ... - Kathrein

9362705b, Operating Manual UFD 170 DVB-S Receiver ... - Kathrein

9362705b, Operating Manual UFD 170 DVB-S Receiver ... - Kathrein

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Initial Setup<br />

This message appears when<br />

“HDP mode” is deactivated.<br />

Press to switch to the main<br />

menu, and then use the <br />

keys to call up the “HDP Antenna Se- Se- Setup”<br />

sub-menu. Use the keys to<br />

change the selection to “On”. Pres-<br />

sing the keys takes you back to<br />

the normal TV screen.<br />

<strong>Receiver</strong> Factory Satellite Setting<br />

18<br />

Time/Timer” section).<br />

If the message “Poor or no signal” appears on the screen as well as<br />

the display for the last programme received, check the installation of<br />

the system and/or the receiver settings. If this only affects individual<br />

programme slots, there may be an interrupted signal from the<br />

broadcaster or a fault in the reception system.<br />

First of all, check the connection confi guration and whether the default<br />

receiver settings are correct for your system. In case of doubt, consult<br />

a specialist engineer.<br />

Your receiver is factory-set up for the satellites listed in the following<br />

table. You do not normally need to make any additional settings.<br />

ASTRA<br />

19° East<br />

TürkSat<br />

42° East<br />

(EURASIA)<br />

Telestar12<br />

15° West<br />

Thor 1° West<br />

(Intelsat 707)<br />

HOTBIRD<br />

Telecom<br />

5° East<br />

(AtlanticBird 3)<br />

Hisparsat<br />

30° West<br />

Sirius 5° East<br />

EUTELSAT<br />

10° East<br />

Telecom<br />

8° East<br />

EUTELSAT<br />

7° East<br />

Arabsat<br />

26° East<br />

EUTELSAT<br />

16° East<br />

ASTRA 28.2°<br />

East (EURO-<br />

BIRD 28.5°)<br />

Amos 4° West

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!